Configuring The Nic - Avaya S8700 Series Installing And Configuring

Hide thumbs Also See for S8700 Series:

Table of Contents

Chapter 4: Media server configuration

Note:

It is not necessary to enable the "Input to Server" ntp service. If this service is

Note:

already enabled, you do not need to disable it.

When the Avaya Installation Wizard prompts you for information about the network time

servers, enter the DNS name or the IP address for the primary network time server and the

secondary and the tertiary time servers if any. If you enter a DNS name instead of an IP address

for the network time server, you must specify the IP address of the DNS server. For more

information, see

For more information about NTP, see RFC 958.

Configuring the NIC

1. From the Maintenance Web Interface, under Server Configuration, click Configure

Server.

2. Click Continue until you get to the "Specify how you want to use this Wizard" page.

3. Select Configure Individual Services and click Continue.

4. On the menu on the left, click Set Identities

5. Use the drop-down menus to assign the Ethernet port functions. Click Continue.

6. Complete the following information for Ethernet 2:

IP address

●

Gateway

●

Subnet mask

●

Speed

●

Installing and Configuring the Avaya S8700-Series Media Server

About the Avaya Installation Wizard

on page 33.

February 2007

Table of Contents