Configuring The Ethernet Switch - Avaya S8700 Series Installing And Configuring

Note:
Avaya Terminal Emulation and HyperTerminal are supported terminal emulation
Note:
applications.
If a Network Management System (NMS) is to monitor the Ethernet switch, you
●
coordinated the assignment of community names with the network administrator. If an
NMS is not used, you set the community names to unique string values.
!
!
SECURITY ALERT:
The Get and Set community name strings are initially configured with the default
SECURITY ALERT:
values of Public and Private, respectively. These community name strings
function as passwords for their respective SNMP operation. Avaya recommends
that you change these community name strings to something other than the
default values. If you leave the defaults in place, a serious security issue can
result.
If the control network is not dedicated, ensure that the 162/udp port for input to server is
●
enabled and the default is disabled. If you do not enable the 162/udp port and disable the
default, the media server cannot receive the traps from either UPS. See
settings

Configuring the Ethernet switch

Note:
Use the default addresses.
Note:
1. Connect the RS-232 serial port of your Services laptop computer to the port labeled
Console on the front of Ethernet switch 1 (CNA). Use the flat cable supplied with the Avaya
Ethernet switch.
2. Open a VT-100 terminal emulation session on your computer.
3. Set the IP address for the Ethernet switch.
4. Set the subnet mask for the Ethernet switch.
5. Set the gateway IP address for the Ethernet switch.
6. Set the IP address of the trap receiver for the Ethernet switch.
7. Set the SNMP community name string for Get, Set, and Trap. For information about setting
these values, see the section on SNMP commands on the documentation CD-ROM that
comes with the Avaya Ethernet switch.
8. Use the command set spantree enabled to verify that spanning tree is enabled. Note
that enabled is the default setting.
Installing and Configuring the Avaya S8700-Series Media Server
Configuring the SNMP subagent in the Avaya Ethernet switch (if used)
on page 37.
Enabling firewall
25
February 2007