Configuring/Address Space; Configuring - Siemens SIMATIC ET 200SP Manual

Configuring/address space

4.1

Configuring

Introduction
The technology module is configured and assigned parameters with the configuration
software.
The technology module functions are controlled and monitored by the user program.
System environment
The technology module can be used in the following system environments:
Applications Components required
Centralized opera-
•
tion with a
CPU 151xSP
•
Technology Module TM Count 1x24V (6ES7138-6AA00-0BA0)
Manual, 02/2017, A5E33002339-AB
Configuration software
STEP 7 (TIA Portal):
S7-1500 automation
system
Operating with technology object
"Counting and measurement"
TM Count 1x24V
•
•
STEP 7 (TIA Portal):
Position input for technology object
"Motion Control"
•
•
STEP 7 (TIA Portal):
Manual operation (without technology
object)
•
STEP 7 (TIA Portal):
Fast Mode
•
Device configuration with hardware
configuration
Parameter setting with
High_Speed_Counter technology
object
Device configuration with hardware
configuration
Parameter setting with axis tech-
nology object
Device configuration and parameter
setting with hardware configuration
Device configuration and parameter
setting with hardware configuration
4
In the user program
High_Speed_Counter in-
struction
Motion Control instructions
Direct access to the control
and feedback interface
(Page 52) in the I/O data
Direct access to the feed-
back interface (Page 56) in
the I/O data
28