Disassemble - Taylor-Dunn BIGFOOT B5-440-36 Operation, T Roubleshooting And Replacement Parts Manual

B5-440-36 / B5-440-48

DISASSEMBLE

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
Refer to illustration of exploded motor (found later
in this section)
1: Mark where the front end housing (3), rear motor
housing (4), and the stator (2) are aligned in
relation to each other.
2: Remove the three screws (24) from the sensor
cover plate (7).
3: Remove the four bolts (22) from the speed sensor
(9).
4: Remove the wire clamps (18/19) and terminal
block hardware (26).
5: Remove the six drive end bolts (21) from the front
motor housing (3).
6: Using a soft face hammer, gently tap on the front
motor housing (3) to remove.
Note: Do not lose the wave washer (15).
MB-440-01
NOTICE
For specific torque values please refer to Hardware
Torque table found at the end of this chapter.
7: Remove the armature (1).
a: Remove the motor encoder (9) by removing the bolts
(23).
b: Gently tap the armature using a soft faced hammer
and 1" hollow pipe around the armature magnet (see
illustration).
c: Reinstall the motor encoder (9) by installing the bolts
(23).
NOTICE
Use CAUTION when removing rear motor housing to
prevent wire damage
8: Using a soft face hammer tap on the rear motor
housing (4) to separate it from the stator (2).
Motor
Page 61