Operating Instructions - WaterLogic WL500 Operating, Installation And Service Manual

The above picture shows front LCD display and control panel for the Waterlogic WL500 .
Button
1
2
3
4
Main Dispense Button
(larger -not shown above)
For Cold Water: Press Cold (Button 1) followed by the Main Dispense Button.
For Sparkling Water: Press Sparkling (Button 2) followed by the Main Dispense Button.
For Hot Water: Press Hot (Button 3) followed by the Main Dispensing Button.
For Extra Hot Water: Press Extra Hot (Button 4), wait approximately 30 seconds. Then press Hot
(Button 3) and the Main Dispensing Button. This procedure will raise the hot
water temperature approximately 2
raise the temperature about 2
up to a maximum limit of 203
NOTE: Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity. The default selection can be programmed to Cold or Sparkling. See Programming section of
this manual.
WL500 Operating, Installation, and Service Manual

OPERATING INSTRUCTIONS

Operational Use
Select Cold Water
Select Sparkling Water
Select Hot Water
Select Extra Hot water
Dispense Selection
o
F more until the desired temperature is reached
o
F.
Programming Mode
Scroll the Menu Down
Scroll the Menu Up
Enter (select) an Option
on the Menu
Escape to Main Menu/Exit
Programming Mode
N/A
o
F. Repeating the process over again will
Page 9 - Revision: 5-29-2015