Node View Card Shortcuts; Node View Tabs - Cisco ONS 15600 Reference Manual

Chapter 4 Cisco Transport Controller Operation
Table 4-3
Port Color
Green
Violet
Figure 4-2
Figure 4-3

4.5.1.2 Node View Card Shortcuts

If you move your mouse over cards in the graphic, popups display additional information about the card
including the card type; card status (active or standby); the type of alarm, such as critical, major, and
minor (if any); and the alarm profile used by the card. Right-click a card to reveal a shortcut menu that
you can use to open, reset, change, or delete a card. Right-click a slot to preprovision a card (that is,
provision a slot before installing the card).

4.5.1.3 Node View Tabs

Table 4-4
Table 4-4
Tab
Alarms
Conditions
78-18400-01
Node View Card Port Colors and Service States (continued)
Service State
Unlocked-enabled
Unlocked-disabled,
automaticInService
Terminal Loopback Indicator
Facility Loopback Indicator
lists the tabs and subtabs available in the node view.
Node View Tabs and Subtabs
Description
Lists current alarms (CR, MJ, MN) for the
node and updates them in real time.
Allows you to retrieve a list of standing
conditions on the node.
Description
The port is fully operational and performing as
provisioned. The port transmits a signal and displays
alarms; loopbacks are not allowed.
The port is out-of-service, but traffic is carried. Alarm
reporting is suppressed. The node monitors the ports for an
error-free signal. After an error-free signal is detected, the
port stays in this state for the duration of the soak period.
After the soak period ends, the port service state changes to
Unlocked-enabled.
Raised fault conditions, whether or not their alarms are
reported, can be retrieved on the CTC Conditions tab or by
using the TL1 RTRV-COND command. The AINS port will
automatically transition to Unlocked-enabled when a
signal is received for the length of time provisioned in the
soak field.
Subtabs
—
—
Cisco ONS 15600 SDH Reference Manual, Release 9.0
4.5.1 Node View
4-9