Asap Card-Level Indicators; Asap Card Port-Level Indicators; Table 2-19 Asap Card-Level Indicators - Cisco ONS 15600 Reference Manual

Chapter 2 Card Reference

2.8.6 ASAP Card-Level Indicators

Table 2-19
Table 2-19
Indicator
STAT LED
SRV LED
LASER ON

2.8.7 ASAP Card Port-Level Indicators

Table 2-20
whether the port is configured for SDH or Ethernet. (On the 4PIO modules, the port-level LEDs are
numbered 1 through 4.)
Table 2-20
Color
Green
Amber
Red
Off
78-18400-01
describes the functions of the card-level LEDs on the ASAP carrier module.
ASAP Card-Level Indicators
Color Description
Red Indicates a hardware fault; this LED is off during normal operation.
Replace the unit if the STAT LED persists. During diagnostics, the
LED flashes quickly during initialization and slowly during
configuration synchronization.
Green/Amber The service mode of the card. Green indicates that the card is in use,
amber indicates that the card is out of service, and off indicates that
the card is either booting or has no power applied.
Green The green LASER ON LED indicates that at least one of the card's
lasers is active.
describes the functions of the port-level LEDs on the 4PIO and 1PIO modules, depending on
ASAP (4PIO and 1PIO Module) Port-Level Indicators
Description for a SDH-Configured Port
Indicates that the port is provisioned.
Indicates that the signal is degraded.
Indicates a signal failure.
Indicates that the port is unprovisioned.
2.8.6 ASAP Card-Level Indicators
Description for an Ethernet-Configured Port
Constant green indicates that there is a link
and no traffic. Flashing green indicates that
there is a link, and the LED flashes at a rate
proportional to the level of traffic being
received and transmitted over the port.
Amber indicates that the link has an issue
inhibiting traffic, such as a signal error, or
disabled port.
Indicates a signal failure.
Indicates that there is no link.
Cisco ONS 15600 SDH Reference Manual, Release 9.0
2-23