Figure 9-5 Scenario 5: Static Route With One Ctc Computer Used As A Destination - Cisco ONS 15600 Reference Manual

Chapter 9 Management Network Connectivity
Figure 9-5
Subnet Mask 255.255.255.0
Default Gateway = 192.168.1.1
Subnet Mask 255.255.255.0
The destination and subnet mask entries control access to the ONS 15600 SDHs:
If a single CTC computer will be connected to a router, enter the complete CTC "host route" IP
•
address as the destination with a subnet mask of 255.255.255.255.
• If CTC computers on a subnet are connected to a router, enter the destination subnet (in this example,
192.168.1.0) and a subnet mask of 255.255.255.0.
If all CTC computers are connected to router, enter a destination of 0.0.0.0 and a subnet mask of
•
0.0.0.0.
Figure 9-6
hop (the next router that a packet traverses to reach its destination), and the cost (number of hops from
source to destination) is 2.
78-18400-01
Scenario 5: Static Route with One CTC Computer Used as a Destination
LAN A
CTC Workstation
IP Address 192.168.1.100
Host Routes = N/A
ONS 15600 SDH #2
IP Address 192.168.3.20
Default Router = N/A
Static Routes = N/A
shows an example. In this figure, the IP address of router interface B is entered as the next
9.2.5 Scenario 5: Using Static Routes to Connect to LANs
Router
IP Address of interface "A" to LAN "A" 192.168.1.1
IP Address of interface "B" to LAN "B" 192.168.2.1
Subnet Mask 255.255.255.0
Int "A"
Int "B"
ONS 15600 SDH #1
IP Address 192.168.2.10
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes
Destination 192.168.1.0
Mask 255.255.255.0
Next Hop 192.168.2.1
Cost = 2
SDH RING
Cisco ONS 15600 SDH Reference Manual, Release 9.0
LAN B
ONS 15600 SDH #3
IP Address 192.168.4.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
9-7