Physical Layer Parameters - Cisco ONS 15600 Reference Manual

12.5.2 Physical Layer Parameters

Figure 12-1
STM-N Card
For PM locations relating to protection switch counts, see the Telcordia GR-1230-CORE document.
Note
Table 12-2
Table 12-2
RS (NE/FE)
RS-EB
RS-ES
RS-SES
RS-OFS
RS-BBE
1. SDH path performance monitoring parameters increment only if IPPM is enabled. For additional information, see the
2. For information about troubleshooting path protection configurations (path protection) switch counts, refer to the
12.5.2 Physical Layer Parameters
The ONS 15600 SDH retrieves the OPR, OPT, and LBC from the line card and stores these values with
the PM counts for the 15-minute and 1-day periods. You can retrieve current OPR, OPT, and LBC values
for each port by displaying the card view in CTC and clicking the Maintenance > Transceiver tabs.
The physical layer performance parameters consist of normalized and non-normalized values of LBC,
OPT, and OPR.
Cisco ONS 15600 SDH Reference Manual, Release 9.0
12-6
PM Read Points on the OC-48/STM16, and OC-192/STM64 Cards
Send to PM manager
via Ethernet
Current
Alarm
defect
agent
table
collection
monitor
lists the near-end and far-end section layer PMs.
OC48/STM16, and OC-192/STM64 Card PMs
MS (NE/FE)
MS-EB
MS-ES
MS-SES
MS-UAS
MS-FC
MS-BBE
"12.2 Intermediate-Path Performance Monitoring" section on page
parameters, log into the far-end node directly.
Cisco ONS 15600 SDH Reference Manual for information about creating circuits with protection switching.
Table 12-3 defines the non-normalized values.
PM
agent
Send via the
O&M Bus
B1, B2,
B3, PJ
HW
1, 2
PSC (NE) PJC (NE)
MS-PSC HP-PPJC-Pdet
MS-PSD HP-NPJC-Pdet
MS-PSC-W HP-PPJC-Pgen
MS-PSD-W HP-NPJC-Pgen
HP-PJCDiff
HP-PJCS-Pdet
HP-PJCS-Pgen
Chapter 12 Performance Monitoring
Send to PM manager
via Ethernet
CXC Card
Current
PM
defect
agent
table
SNCP
1+1
switch
switch
count
agent
SNCP
agent
VC4 and VC4-Xc HP Path
(NE)
HP-BBE
HP-BBER
HP-EB
HP-ES
HP-ESR
HP-SES
HP-SESR
HP-UAS
12-2. To monitor SDH path performance monitoring
78-18400-01