Figure 2-4 Traffic Limit And Statistics Configuration Example - Zte ZXR10 5900E Series Configuration Manual

Figure 2-4 Traffic Limit and Statistics Configuration Example

Configuration Flow
1. Configure an ACL for traffic classification. According to the current requirement, the
traffic classification must be done on the basis of the destination IP address, so the
IPv4-access-list is required. To perform statistics on the traffic of two departments, an
ACL rule must be configured.
2. To ensure the QoS of the VOD, configure a priority and allocate a higher priority to the
VOD.
3. Configure the traffic limit, and restrict the bandwidth of the traffic that accesses the
192.168.3.100 agent.
4. Configure traffic statistics, and perform statistics on the traffic that accesses the
192.168.3.100 agent.
Configuration Commands
Configuration on the switch:
/*Configuring ACL rule*/
ZXR10(config)#ipv4-access-list managerA
ZXR10(config-ipv4-acl)#rule 10 permit tcp any 192.168.4.70 0.0.0.0
ZXR10(config-ipv4-acl)#rule 20 permit ip any 192.168.3.100 0.0.0.0
ZXR10(config-ipv4-acl)#rule permit any
ZXR10(config-ipv4-acl)#exit
/*Binding the interface of network A*/
SJ-20150114102049-008|2015-01-15 (R1.0)
Chapter 2 Flow QoS Configuration
2-13
ZTE Proprietary and Confidential