Zte ZXR10 5900E Series Configuration Manual page 31

Tip:
1. The out-vlanID command in the priority label configuration is conflicted with next-hop
or next-hop-ipv6 in the redirection commands. When two commands are configured
at the same time, the packet is only redirected to next-hop or next-hop-ipv6. In this
case, the remark out-vlanID command becomes invalid.
2. The redirection command only takes effect on the ingress.
Configuring Priority Mark
To configure priority mark, perform the following steps:
Step Command
1
ZXR10(config)#
2
ZXR10(config-pm-qos)#
ipv4-mix| ipv6-access-list| link-acl|ipv6-mix}< WORD>
rule-id < 1-2147483644>{[cos <0-7>]|[local-precedence
<0-7>]}[drop-precedence {high}|{medium}|{low}]{[dscp
<0-63>]|[precedence <0-7>]}[out-vlanID <1-4094>]
Descriptions of the parameters in Step 2:
Parameter
{ipv4-access-list| ipv4-mix|
ipv6-access-list| link-acl|ipv6-mix}<
WORD>
rule-id < 1-2147483644>
[cos <0-7>]
[drop-precedence {high}|{medium}|{l
ow}]
[dscp <0-63>]
[out-vlanID <1-4094>]
[local-precedence <0-7>]
[precedence <0-7>]
SJ-20150114102049-008|2015-01-15 (R1.0)
pm-qos
priority-mark {ipv4-access-list|
Description
The type and name for the bound ACL rule.
The number of the ACL rule where the configuration takes
effect.
Modifies the vlan priority for a packet.
Modifies the drop priority for a packet.
Modifies the dscp of a packet.
Modifies the external vlanid of a packet.
Modifies the local priority.
Modifies the IP priority of the packet (TOS field).
2-9
Chapter 2 Flow QoS Configuration
Function
Enters pm-qos configuration
mode
Configures the priority label.
Run the no priority-mark
{ipv4-access-list|
ipv4-mix| ipv6-access-list|
link-acl|ipv6-mix}< WORD>
rule-id < 1-2147483644>
command to cancel the priority
label configuration.
ZTE Proprietary and Confidential