Configuration Command - Zte ZXR10 5900E Series Configuration Manual

ZXR10 5900E Series Configuration Guide (QoS)

Configuration Command

Run the following commands on S1:
/*Configuring the ACL rule.*/
ZXR10(config)#ipv4-mixed-access-list limit_A
ZXR10(config-ipv4-mixed-acl)#rule 1 permit link-protocol 2048 any any
outer-vlan 10 ip any any
ZXR10(config-ipv4-mixed-acl)#rule 2 permit any any ip any any
ZXR10(config-ipv4-mixed-acl)#exit
/*Binding the interface of department A*/
ZXR10(config)#ipv4-mixed-access-group interface gei-0/1/1/3 ingress limit_A
/*Configuring the traffic limit.*/
ZXR10(config-pm-qos)#traffic-limit-acl ipv4-mix limit_A rule-id 1 cir
100000 cbs 200 ebs 3000 mode blind
ZXR10(config-pm-qos)#exit
ZXR10(config)#
/*Configuring the ACL rule.*/
ZXR10(config)#ipv4-mixed-access-list limit_B
ZXR10(config-ipv4-mixed-acl)#rule 1 permit link-protocol 2048 any any
outer-vlan 20 ip any any
ZXR10(config-ipv4-mixed-acl)#rule 2 permit any any ip any any
ZXR10(config-ipv4-mixed-acl)#exit
/*Binding the interface of department B.*/
ZXR10(config)#ipv4-mixed-access-group interface gei-0/1/1/21 egress limit_B
/*Configuring the priority label.*/
ZXR10(config)#pm-qos
ZXR10(config-pm-qos)#traffic-limit-acl ipv4-mix limit_B rule-id 1 cir
100000 cbs 200 ebs 3000 mode blind
ZXR10(config-pm-qos)#exit
ZXR10(config)#
Configuration Verification
Check QoS configuration results.
/*Checking the ACL configuration.*/
ZXR10(config)#show ipv4-mixed-access-list name limit_A
ipv4-mixed-access-list limit_A
2/2 (showed/total)
rule 1 permit link-protocol 2048 any any outer-vlan 10 ip any any
rule 2 permit any any ip any any
ZXR10(config)#show ipv4-mixed-access-list name limit_B
ipv4-mixed-access-list limit_B
2/2 (showed/total)
rule 1 permit link-protocol 2048 any any outer-vlan 20 ip any any
rule 2 permit any any ip any any
SJ-20150114102049-008|2015-01-15 (R1.0)
2-26
ZTE Proprietary and Confidential