Installing The Front Bezel; Removing And Installing The Power Distribution Module Cover; Removing The Power Distribution Module Cover; Figure 26. Installing The Front Bezel - Intel H2000G series Service Manual

Server chassis

Hide thumbs Also See for H2000G series:

Table of Contents

3.2.3

Installing the Front Bezel

Note: Before installing the front bezel, the rack handles must be installed.

To install the front bezel, lock the right side of the bezel to the rack handle (A) and press the left side of the

bezel towards the chassis until it clicks into place (B) as pictured in Figure 26.

3.3

3.3.1

The server chassis must be operated with the power distribution module cover in place to ensure proper

cooling. Remove the cover to add or replace the components inside of the chassis. Before removing the cover,

power down the server and unplug all peripheral devices and the power cables.

Note: A non-skid surface or a stop behind the server chassis may be needed to prevent the server chassis

from sliding on the work surface.

To remove the power distribution module cover, refer to Figure 27.

1. Remove the screw (A).

2. Lift the cover from the front end to more than 45 degrees (B) and remove the cover.

Intel® Server Chassis H2000G Product Family Service Guide

Table of Contents