Intel® Server Chassis H2000G Product Family Service Guide
2. Install the drive cage to the chassis (D) and fix the drive cage with the screws (E, F, and G) as pictured in
Figure 55.
Figure 55. Installing the drive cage to the chassis
3. Reconnect all cables to the backplane board.
4. Reconnect the front panel cable to the backplane interposer board.
5. Install the power interposer board. For instructions, see section 3.11.2
6. Install the power distribution module cover. For instructions, see section 3.3.2
7. Install all hot-swap drive carriers, if removed.
3.10 Removing and Installing the Power Distribution Module
3.10.1
Removing the Power Distribution Module
1. Remove the cover and the power supply units from the chassis.
2. Remove the power cables and PMBus* cable between the power distribution module and the backplane.
3. Remove the two screws (A) and slide the power distribution module and lift it (B) as pictured in Figure 56.
Figure 56. Removing the power distribution module
37