Replacing The 16 X 2.5" Backplane Board; Removing The 16 X 2.5" Backplane Board; Figure 47. Installing The Drive Cage To The Chassis; Figure 48. Removing The Drive Cage - Intel H2000G series Service Manual
Server chassis
Hide thumbs
Also See for H2000G series:
- Configuration manual (32 pages) ,
- Configuration manual (34 pages) ,
- Service manual (35 pages)
Table of Contents
Advertisement
Intel® Server Chassis H2000G Product Family Service Guide
2. Install the drive cage to the chassis (C) and fix the drive cage with the screws (D, E and F) as pictured in
Figure 47.
Figure 47. Installing the drive cage to the chassis
3. Reconnect all cables to the backplane board.
4. Install the power distribution module cover. For instructions, see section 3.3.2.
5. Install all hot-swap drive carriers, if removed.
3.8
Replacing the 16 x 2.5" Backplane Board
3.8.1
Removing the 16 x 2.5" Backplane Board
1. Remove all hot-swap drive carriers, regardless of whether a drive is installed in the carrier.
2. Remove the power distribution module cover. For instructions, see section 3.3.1.
3. Disconnect all cables from the backplane board.
4. Remove the drive cage screws (A, B and C) and pull out the drive cage (D) as pictured in Figure 48.
Figure 48. Removing the drive cage
33
Advertisement
Table of Contents
