System Assembly - Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual

Raster to Vector Conversion Software (user supplied)
Adobe Streamline or CorelTRACE
CAD Software (user supplied)
AutoCAD or AutoCAD LT for Windows
FONTS (user supplied)
True Type fonts ONLY. Do not use PostScript or bitmapped fonts.

System Assembly

If the doorway is not wide enough to allow to you roll the laser system through it, the system MUST be
detached from the cart stand, rotated sideways, passed through the doorway, then re-attached to the
cart stand. If your doorway is wide enough, you can skip the following procedure and proceed to
"Leveling the System". It would help if you had a PADDED floor dolly to transport the machine
through the doorway. If one is not available, it will need to be carried through the doorway.
The laser system without the cart stand weighs approximately 200 lbs.
assistance from as many people as possible (3 or 4 people). Always use a back-
support device when lifting. Do not attempt lifting the machine if you are physically
handicapped or are injured in any way. Seek the advice of a physician if you are
unsure.
1. Make sure unit is unplugged
an electrical outlet.
2. At the back of the system, locate
four screws; remove them and
you will need to release the
latches to pull the connectors
4. Open the rear
pressing down on the button
the latches until the latches pop
5. Fold the rear cover down to a
resting position.
INSTALLATION
cover by
Section 2-3
black connector that attaches the wire
harness to the power supply.
three connectors. They are held in place by
Obtain
from
the
the
cover
plate.
3. Locat
e the
two,
white
conne
ctors
and
the
one,
Unplug all
latche
s so
off.
part of
up.