Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual page 17

INSTALLATION
Laser Cartridge Installation
Before connecting and powering on your system, you must install the laser cartridges. Make sure that
your power cord IS NOT plugged in at this time. Press on the backside of the two hinges to release
the latches. Gently fold back the rear cover.
Visually locate the two mounting blocks (1), the laser latch (2), alignment fork (3), and power
connector (7). Notice that the alignment fork has two plates, one small (4) and one large (5). Locate
the gap between the two plates (6).
Open the rear cover and visually locate the laser mounting blocks, the laser latches, and alignment
forks. Notice that the alignment forks have two plates, one small and one large. Locate the gap
between the two plates. Observe the "V" groove along the upper (3) and lower (2) part of the laser
cartridge and the alignment plate (1) at the end.
Pick up the laser cartridge by the sides. Tilt the laser cartridge downward on a 30-degree angle. If
you have purchased two lasers, mount the first cartridge onto the LOWER mounting blocks. Place
the upper "V" groove of the cartridge on top of the mounting blocks. Slide the cartridge to the right
until the alignment plate of the laser cartridge makes contact with the inside of the large plate of the
alignment fork and is centered in the gap between the small and large plates of the alignment fork.
Mount the second Laser Cartridge on the top mounts in the same manner as the bottom Laser
Cartridge.
The power connectors are labeled "Top" and "Bottom". It is very important that you plug in the correct
connector into the each laser, otherwise the laser system will not function properly. The power
connectors are keyed so it will only insert one way. Close the rear cover, making sure that you do not
pinch any wires, and push down on the latches until they "click".
Section 2-5