Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual page 23

MEMORY CONTROL
The laser system is equipped with 16 Megabytes standard and is expandable to 32 Megabytes to
store downloaded files while the system is powered ON. Eventually the memory will fill up with files
that will need to be deleted to free up space for more files. To delete one file at a time, display the
desired file by using PREVIOUS FILE or NEXT FILE buttons. Use the UP or DOWN arrow button to
position the cursor on the DELETE THE FILE menu item and then press SELECT. Select a CANCEL
or YES response to the ARE YOU SURE question. To completely clear out all files at the same time,
position the cursor on the DELETE ALL FILES option and press SELECT.
DOS POWER SETTINGS
Use this menu selection ONLY if you are printing from a DOS based CAD program that can output
pure HPGL. Here you can assign POWER, SPEED, and PPI to the pen numbers as if you were
assigning pen colors to a flatbed plotter. Since using this menu feature has many limitations, we
suggest using only Windows based software.
PREFERENCES
Options, diagnostic, and maintenance features are found within this menu selection. If you change
anything within this menu, and would like those changes to remain, next time you power ON the
system, make sure you ESCAPE back to the MAIN menu before turning off the laser
OPTIONS
Select this menu to access optional features that your system may have.
ONE FILE MEMORY
Pressing SELECT will toggle the setting ON (ONE FILE MEMORY enabled) and OFF
(MULTIPLE FILE MEMORY enabled). The purpose of ONE FILE MEMORY is to
store only one file in the laser system's memory. Successive file downloads erase
the previous file in memory, avoiding the need to constantly clear the memory or
press the NEXT FILE button. This feature is useful if you only run files only once.
However, if you want to repeat the file that is memory, you may do so as many times
as you want providing that you do not download a new file or power the system off.
While this mode is ON, we recommend that you do not print to the laser system until
it has finished processing the current file, otherwise you may get a "printer timeout"
error displayed on your computer. This is because that while the laser system is
running, the parallel port blocks the incoming file from erasing the file you are running.
When the file is finished running or you PAUSE the file, the port opens and allows the
new file to replace the current file. Be careful when using this feature.
AUTOFOCUS
The SELECT button will toggle this setting ON (AUTOFOCUS enabled) and OFF
(manual focus enabled). Refer to the FOCUSING METHODS section on how to use
this feature.
AIR ASSIST
Air Assist is an optional accessory. If you have purchased this option, please refer to
the OPTIONS and ACCESSORIES section of the manual for more information.
DUAL HEAD
Dual Head is also an optional accessory. If you have purchased this option, please
refer to the OPTIONS and ACCESSORIES section of the manual for more
information.
CONFIGURATION
Selecting this menu will allow the reconfiguration of certain features of the laser system.
SYSTEM OPERATION
Section 3-3