Section 2 - Installation; System Operating Environment Requirements - Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual

Section 2
Installation
The following operational guidelines are vital to a safe and productive environment.
responsibility to provide a proper operating environment.
Damage to the laser system due to an inadequate or improper operating environment
is considered abuse and WILL NOT be covered under warranty. In no event will ULS
be liable for any damages caused, in whole or in part, by customer, or for any
economic loss, physical injury, lost revenue, lost profits, lost savings or other indirect,
incidental, special or consequential damages incurred by any person, even if ULS
has been advised of the possibility of such damages or claims.
System Operating Requirements
Environment (user supplied)
The laser system MUST be installed in an office-type or light duty manufacturing environment.

Dusty or dirty air environments can damage the laser system. Keep the laser system isolated
from any type of sandblasting, sanding, oily, or any other machinery that produces airborne
particles.
Avoid small, enclosed, non-ventilated areas. Some materials, after laser engraving or cutting,

continue emitting fumes for several minutes after processing. Having these materials present in a
confined, unventilated room can contaminate the room.
For best results, since the lasers are air-cooled, we recommend operating the laser system

between the ambient temperatures of 73ºF (22ºC) to 77ºF (25º C). However, the system can
operate between the temperatures of 50ºF (10ºC) to 95ºF (35º C). The laser cartridge has
thermal sensors that will not permit it to operate outside of these parameters.
Avoid storing the laser system outside the temperatures of 50ºF (10ºC) to 95ºF (35º C) as

excessively cold or hot temperatures can damage the laser cartridge.
Ambient humidity levels must be non-condensing.

Electrical (user supplied)
Refer to the "INPUT POWER" label near the system's ON/OFF switch and power inlet for your

system's electrical requirements.
Never remove the ground lead to the electrical cord and plug the system into a non-

grounded outlet. This is very dangerous and can lead to a severe, if not fatal, electrical shock.
Always plug the system into a properly grounded (earthed) outlet.
Noisy or unstable electricity as well as voltage spikes can cause interference and possible

damage to the electronics of the laser system. If electrical power fluctuations, brown outs, or
constant power outages are a problem in your area, an electrical line stabilizer, UPS
(Uninterruptible Power Supply), or backup generator might be required. You may also need to
connect the laser system to a dedicated electrical line to resolve the problem.
An IT type of electrical supply is acceptable if a standard power source is unavailable. An IT

power system is a power distribution system having no direct connection to earth, the exposed
conductive parts of the electrical installation being earthed.
It is your