System Assembly - Universal Laser Systems X-660 Safety, Installation, Operation, And Basic Maintenance Manual

• Raster to Vector Conversion Software (user supplied)
Adobe Streamline or CorelTRACE
• CAD Software (user supplied)
AutoCAD or AutoCAD LT for Windows
• FONTS (user supplied)
Use True Type fonts ONLY. Do not use PostScript or bitmapped fonts.

System Assembly

If the doorway is not wide enough to allow to you roll the laser system through it, the system MUST be
detached from the cart stand, rotated sideways, passed through the doorway, then re-attached to the cart
stand. If your doorway is wide enough, you can skip the following procedure and proceed to "Leveling the
System". It would help if you had a PADDED floor dolly to transport the machine through the doorway. If
one is not available, it will need to be carried through the doorway.
The laser system without the cart stand weighs approximately 200 lbs. Obtain assistance
from as many people as possible (3 or 4 people). Always use a back-support device
when lifting. Do not attempt lifting the machine if you are physically handicapped or are
injured in any way. Seek the advice of a physician if you are unsure.
1. Make sure unit is unplugged from an electrical
outlet.
2. At the back of the system, locate the four
screws; remove them and the cover plate.
INSTALLATION
3. Locate the two, white connectors and the one,
black connector that attaches the wire harness
to the power supply.
connectors. They are held in place by latches
so you will need to release the latches to pull
the connectors off.
4. Open the rear cover by pressing down on the
button part of the latches until the latches pop
up.
5. Fold the rear cover down to a resting position.
Section 2-3
Unplug all three