Fcc Compliance - Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual

FCC Compliance

This ULS laser system has been tested and found to comply with Federal Communication
Commission (FCC) directives regarding Electromagnetic Compatibility (EMC). In accordance with
these directives ULS is required to provide the following information to its customers.
This device complied with FCC Rules Part 15. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device as set
forth in Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with manufacturer's instructions, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his or her own expense.
Users should be aware that changes or modifications to this equipment not expressly approved by the
manufacturer could void the user's authority to operate the equipment.
This equipment has been type tested and found to comply with the limits for a Computing Device per
FCC part 15, using shielded cables. Shielded cables must be used in order to insure compliance with
FCC regulations.
FCC Compliance Statement and Warnings
Section 1-5
SAFETY