Rubber Stamps - Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual

RASTER ENGRAVING
LASER WATTAGE
25
30
35
40
45
50
55
60
PERFORATED VECTOR CUTTING
LASER WATTAGE
25
30
35
40
45
50
55
60
To create a rubber stamp, use the Rubber Stamp Mode the printer driver. In the above example, only
one pass is necessary to achieve a deeply engraved rubber stamp. When cutting out the rubber
stamp, we recommend using a very low PPI setting. This setting spreads the laser pulses far enough
apart that they just touch at the edges. The result is a perforated cut that allows the rubber stamp to
remain attached to the entire sheet but easily removed by simply tearing it off. The advantage to this
is that the possibility of distortion or melting while cutting is virtually eliminated and the entire sheet of
rubber stamps can be removed from the machine at one time instead of having to pick them up one
by one.
 LASER ENGRAVING OR CUTTING RUBBER CAN IGNITE THE MATERIAL.
Never leave the laser system running unattended for any reason.
 LASER ENGRAVING OR CUTTING RUBBER CAN PRODUCE FOUL ODORS.
You might need to particulate filter and/or odor filter your exhaust depending on
your environment, installation location, and/or your local air quality control laws.
LASER ENGRAVING OR CUTTING RUBBER PRODUCES ABRASIVE DUST.

Clean the laser system more frequently to reduce wear and tear on the motion
system components and optics. Damage to the laser system from inadequate or insufficient
maintenance ARE NOT covered under warranty.
MATERIAL SETTINGS GUIDE

RUBBER STAMPS

POWER SPEED
100
100
100
100
100
100
100
100
POWER SPEED
60
60
60
60
60
60
60
60
COMMENTS
Section 5-20
PPI
10 500
12 500
14 500
16 500
17 500
20 500
22 500
23 500
PPI
1.3 90
1.6 90
1.8 90
2.1 90
2.3 90
2.6 90
2.9 90
3.1 90
PASS DEPTH
1 .030"
1 .030"
1 .030"
1 .030"
1 .030"
1 .030"
1 .030"
1 .030"
PASS DEPTH
1 .040"
1 .040"
1 .040"
1 .040"
1 .040"
1 .040"
1 .040"
1 .040"