Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual page 80

Place the bracket on the table (1). Insert the thumbscrews and washers (2) into the screw holes

but do not tighten down completely. Leave the thumbscrews loose enough so that the bracket
can slide.
1
2 3 4 5 6 7 8 9 10
1
2
3
4
5
6
7
8
9
10
11
12
Place the Rotary Fixture on a flat surface. Using an Allen wrench, attach the two socket head

shoulder screws (1) to the side of the base plate.
 Place the Rotary Fixture on top of the bracket so that its pivot bolts set into the forks in the
bracket. Gently push the fixture (1) flat up against the top ruler.
thumbscrews (2).
 With the power to the system still OFF, connect the 9-pin Rotary Fixture control cable to the
receptacle on the laser engraving system (1).
1
2
3
4
5
6
7
8
9
10
11
12
Before loading the glass into the fixture, measure the diameter of the glass in the

area where the engraving is to be located by using a caliper or similar measuring
device. Either remember this number or write it down.
Place the open end of the glass on the right side of the Rotary Fixture. Lift the

lever (1) on the adjustable end of the fixture and slide it up against the base of
the glass so the glass rests firmly centered inside of the inverted cone. Push the
adjustable end of the fixture (2) to the right, firmly against the bottom of the glass. Do not to apply
too much pressure, especially with glass. You only need enough pressure to prevent the object
from slipping on the cone while it rotates. Lower the lever on the end of the fixture to lock it in
place.
ACCESSORIES
11 12 13 14 15 16 17 18 19 20 21 22 23 24
1
1 2 3 4 5 6 7 8 9
1
2
3
4
5
6
7
8
9
10
11
12
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Section 6-14
2
10 11 12 13 14 15 16 17 18 19 20 21
1
2
17 18 19 20 21 22 23 24
READY
1
NOW, tighten down the
22 23 24
WARNING
TURN THE LASER SYSTEM OFF BEFORE
CONNECTING OR DISCONNECTING
THE ROTARY FIXTURE
1