Universal Laser Systems X-600 Safety, Installation, Operation, And Basic Maintenance Manual page 76

If there is a button head screw located on the top of the Dual Head and or the single head,

remove it.
Pick up the Dual Head tube and note the "L" (Left) and "R" (Right) markings. Install the tube

using the supplied thumbscrews and tighten securely.
 If you have the Air Assist option, locate the 1 (one) black
thumbscrew on the side of the Single Head. This thumbscrew
serves two purposes, it blocks air from coming out when in Single
Head operation and secures the Dual Head Air Hose when in Dual
Head operation. Regardless of whether or not you will be using
the Air Assist option, you should always attach the Air Hose to get
it out of the way. REMINDER: If you have the Air Assist option
and will not be using it, you MUST remove the air assist
cone(s) before operating the system otherwise damage to the
Focus Lens will
documentation on how to remove the cone(s) properly.
Installation is now complete. Turn the laser system ON and observe the control panel display.

Above the "Initializing" statement you should see "(DH)" next to the model name indicating that
you are now in "Dual Head" mode.
Press the "X-Y" button to illuminate the Red Diode Pointer. You will notice that the Single Heads

red dot will be brighter than the Dual Head's red dot. This is because the Beam Splitter, inside
the Dual Head does not reflect/pass visible light at a 50/50 ratio. Using the Motion Controls,
position the Dual Head all the way as far as it will go into the upper left corner of the engraving
area (0,0). It should be relatively close to (0,0) with +/- 1/16
position of the Single Head red dot. This is the (0,0) position of the second object and your
reference point for placing your material.
ACCESSORIES
L
2.0
DUAL HEAD
occur. Refer to
Remove the thumbscrew and attach the end of the air

hose to the single head by inserting the brass tube into the
hole where the thumbscrew was removed.
thumbscrew into the other threaded hole (right next to the
original hole), and tighten securely.
Section 6-10
R
Beam Tube
your Air Assist
th
of an inch. Now observe the
2.0
Attach the