Table of Contents
Advertisement
2-4
Installation
Locate the Pre-Filter (1), the Main Filter (2) (may
•
or may not be pre-installed), the Vacuum Motor
attachment thumbscrews (3) and the Vacuum
Motor (4). If the Main Filter is not installed, locate
the filter, remove the plastic wrapping, and slide it
into the Filter Module, as far as it will go, with the
Red Arrow pointing straight up. The Filter Module
will not operate if the Red Arrow is not pointing
straight up.
Close the door and secure the latches.
•
Laser Cartridge Installation
With your finger, press the circular button on the
•
latch and it will pop out.
1) Mounting Blocks
2) Laser Latch
3) Alignment Fork
Cartridge.
Gently fold the rear cover up and over the top door.
Visually locate the two Mounting Blocks, the Laser
Latch, and the Alignment Fork. Locate the small
notch in the Alignment Fork.
Observe the "V" groove along the upper and
•
lower part of the Laser Cartridge. Also locate
the Alignment Plate at the end of the Laser
1) Upper V-groove
2) Lower V-groove
3) Alignment Plate
Advertisement
Table of Contents
