KEB COMBIVERT F5 Series Instruction Manual page 32

Error Assistance
Display COMBIVIS
A.OH2 Warning ! motor protection
A.OHI Warning ! overheat internal
A. OL Warning ! overload
A.OL2 Warning ! overload 2
A.PrF Warning ! prot. rot. for.
A.Prr Warning ! prot. rot. rev.
A.SbuS Warning ! synchron
A.SEt Warning ! set
Warning ! Software limit
A.SLF
switch forward
Warning ! Software limit
A.SLr
switch reverse
Value Meaning
Warning: electronic motor protective relay has tripped. The response to
97
this warning can be programmed.
The temperature in the interior of the inverter lies above the permissible
87 level. The switch off time was started. The programmed response to this
warning message is executed.
A level between 0 and 100 % of the load counter can be adjusted, when
99 it is exceeded this warning is output. The response to this warning can
be programmed.
The warning is output when the standstill continuous current is exceeded
(see technical data and overload characteristics). The response to this
100
warning can be programmed. The warning message can only be reset
after the cooling time has elapsed and A.nOL2 is displayed.
The drive has driven onto the right limit switch. The response to this
94
warning can be programmed.
The drive has driven onto the left limit switch. The response to this
95
warning can be programmed.
Sychronization over sercos-bus not possible. The response to this
103
warning can be programmed.
It has been attempted to select a locked parameter set. The response to
102
this warning can be programmed.
The target position lies outside of the limit defined with the right software
104
limit switch. The response to this warning can be programmed.
The target position lies outside of the limit defined with the left software
105
limit switch. The response to this warning can be programmed.
GB - 29