KEB COMBIVERT F5 Series Instruction Manual page 23

Parameter description
Value Function
0 No function (generally off)
1 Generally on
2 Run signal; also by DC-braking
3 Ready signal (no error)
4 Fault relay
5 Fault relay (not at under voltage error)
6 Warning or error message at abnormal stopping
7 Overload alert signal
8 Overtemperature alert signal power modules
9 External overtemperature alert signal motor
10 Only application mode
11 Overtemperature alert signal interior OHI
12...19 Only application mode
20 Actual value = set value (CP.3 = Fcon; rcon; not at noP, LS, error, SSF)
21 Accelerate (CP.3 = FAcc, rAcc, LAS)
22 Decelerate (CP.3 = FdEc, rdEc, LdS)
23 Real direction of rotation = set direction of rotation
24 Utilization > switching level
25 Active current > switching level
26 Only application mode
27 Real value (CP.1) > switching level
28 Setpoint (CP.2) > switching level
29...30 Only application mode
31 Absolute setpoint at AN1 > switching level
32 Absolute setpoint at AN2 > switching level
33 Only application mode
34 Setpoint at AN1 > switching level
35 Setpoint at AN2 > switching level
36...39 Only application mode
40 Hardware current limit activated
41 Modulation on-signal
42...46 Only application mode
47 Ramp output value > switching level
48 Apparent current (CP.4) > switching level
49 Forward running (not at nOP, LS, abnormal stopping or error)
50 Reverse running (not at nOP, LS, abnormal stopping or error)
51 Warning E.OL2
52 Current regulator limit reached
53 Speed regulator limit reached
54...62 Only application mode
63 Absolute value ANOUT1 > switching level
64 Absolute value ANOUT2 > switching level
65 ANOUT1 > switching level
66 ANOUT2 > switching level
67...69 Only application mode
70 Driving current active (safety relay)
71...72 Only application mode
73 Absolut active power > switching level
74 Active power > switching level
75...79 Only application mode
80 Active current > switching level
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
1)
further on next side
GB - 23