Changing Between Op And Dos Modes - Siemens simatic hmi op27 Equipment Manual

Operating modes
15.2

Changing Between OP and DOS Modes

Change from OP
Proceed as follows to switch from OP mode to DOS mode:
mode to DOS
mode
Changing from Switching from DOS mode to OP mode is performed using the BIOS Setup, as
DOS mode to OP
described in Chapter 15.1.
mode
15-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Step
1 Press the three arrow keys depicted on the right
simultaneously while the OP is starting up.
2 The OP then requests the boot medium. Select:
S
Disk for hard disk/floppy disk drive
S
PCMCIA: HD for memory module.
3 The OP then boots from the medium specified and starts up again, this
time in DOS mode. This presupposes that the medium has been formatted
as a boot medium.
The DOS mode setting remains stored for future startups of the OP37.
Action
+
OP27, OP37 Equipment Manual
Release 05/99
+