Siemens simatic hmi op27 Equipment Manual page 120

12.2 Installing the OP37
The OP37 is designed for vertical installation in:
S
S
Installing in 19" When installing in 19" panels or racks, use the shaped rails from the panel or
cabinets/racks rack manufacturer concerned. The mounting dimensions and the method of
securing the OP37 are shown in the following table.
Installing in front
panels of cabinets
and consoles
OP27, OP37 Equipment Manual
Release 05/99
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
19" panels/racks,
front panels of cabinets and consoles.
Mounting dimensions for a standard 19"
panel:
S
Width
S
Height
Securing the OP
Step
1 Working from the front, insert the OP37 in the mounting cutout prepared.
Make sure the OP cannot drop out of the front panel before it has been
secured.
2 Insert the hooks of the six enclosed screw-type clamps
sponding recesses in the housing of the OP37.
Front panel
Ê
Mechanical Installation
Mounting Dimensions
19" (482.6 mm)
7 height modules (310 mm)
Four screws on the shaped rails
Action
Ê
Ê
Ê
Ê
Ê
in the corre-
OP37
Ê
12-3