Printing Messages; Op27, Op37 Equipment Manual Release 05/99 I - Siemens simatic hmi op27 Equipment Manual

6.4

Printing Messages

How to print
Alarm and event messages can be printed out
S
S
S
Set the printer parameters in the Printer Settings standard screen. The standard
screen is described in Chapter 7.
Direct message Alarm and event messages can be printed out directly on arrival and departure
logging
(alarm messages too, following acknowledgement) when this has been defined
in the message configuration. System messages are not logged.
Direct message
Direct message logging can be enabled/disabled online via the OP using the
logging on/off System Settings standard screen. To do so, open the input window in the
MESSAGE LOGGING
or
The table shows the relationships between the settings on the OP and those
configured in ProTool.
OP27, OP37 Equipment Manual
Release 05/99
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
automatically, following buffer overflow (see Chapter 6.3),
automatically, as direct message logging.
manually (refer to Chapter 6.5.1).
Note
If the message buffer overflows as a result of a messages overload, it is pos-
sible that messages cannot be printed. If this happens "****" appears in the
printout instead of messages.
symbolic input field and select the required parameter
.
ON
Setting in ProTool
Message Logging ON
Message event Messages are logged
Buffer overflow Messages are logged
Off Messages are logged
Note
If Asian character sets are used for messages, the messages are printed in
graphics mode.
Messages
Setting on OP
Message Logging OFF
Messages are not logged
Buffer overflow is printed
No effect
OFF
6-13