Tiller Handle/Shaft Bracket Installation - Mercury 75 Service Manual

17. Attach sta-strap to end of harness sleeve.
b
a - Sta-strap
b - J-clip
18. Install rubber twist grip by aligning ridges on plas-
tic twist grip with grooves inside of rubber grip.
NOTE: Applying a soapy water solution to rubber grip
will ease installation.
a - Ridges
b - Grooves (under handle)
7B-16 - ATTACHMENTS/CONTROL LINKAGE
a
51603
a
b
51603
Tiller Handle/Shaft Bracket
Installation
1. Slide bracket over steering arm studs. Secure
bracket to arm with retained nuts and NEW tab
washers.
Torque nuts to 40 lb. ft. (54.0 N
m).
Bend locking tabs against flats of nuts.
b
a
c
a - Tab Washer
b - Nut
c - Steering Arm
2. Install retained spring and detent pin into tiller
handle bracket.
a - Spring
b - Detent Pin
90-830234R3 DECEMBER 1997
51621
b
a
51621