Mercury 75 Service Manual page 243

Remove 8 powerhead to driveshaft housing
mounting nuts and washers (4 each side).
a
a - Nuts and Washers (4 Each Side)
Screw lift eye (91-90455) into flywheel at least 5
full turns.
Use suitable lifting device to remove powerhead
from driveshaft housing and install on powerhead
stand.
a - Lift Eye (91-90455)
90-830234R3 DECEMBER 1997
Remove Air Box Cover by removing 6 screws.
a
19070
a - Air Box Cover
b - Screws
b
a
a
a - Air Box Cover
b - Screws
Remove bolt from lower oil tank support (star-
board side of engine, base).
Remove bolt from upper oil tank support.
25929
Remove 2 bolts securing voltage regulator.
Remove air box by removing nuts/bolts and pull-
ing off of carburetor studs.
b
b
3 Cylinder Models
4 Cylinder Models
POWERHEAD - 4-31
a
53977
b
53976