8. Place roller of cam follower against throttle cam
and adjust idle stop screw to align raised mark of
throttle cam with center of cam follower roller.
Tighten locknut.
b
e
a
b
b
d
a - Cam Follower Adjustment Screw
b - Synchronizing Screws
c - Throttle Arm
d - Idle Stop Screw
e - Roller
f - Throttle Cam
g - Locknut
9. Holding throttle arm at idle position, adjust cam
follower so that a clearance of 0.005 in. - 0.020 in.
(0.13mm - 0.51mm) exists between roller and
throttle cam. Tighten screw securing cam
follower.
0.005 – 0.020
(0.13 – 0.51mm)
a
c
a - Roller
b - Throttle Cam
c - Screw
2C-6 - ELECTRICAL
f
c
g
53432
b
53433
10. Hold throttle arm against full throttle stop. Adjust
full throttle stop screw to allow throttle shutters to
open fully. To prevent throttle shutters to act as a
stop, screw in stop screw until there is a gap of
0.015 in. (0.40mm) between roller of cam follow-
er and throttle lever.
b
a - Throttle Arm
b - Full Throttle Stop Screw
11. Hold throttle cam in full throttle position. If neces-
sary adjust acceleration pump adjusting bolts
position so that a gap of 0.030 in. (0.76mm) exists
between throttle cam and top of acceleration
pump aluminum housing.
c
a
d
a - Throttle Cam
b - Bolts
c - 0.030 in. (0.76mm) Gap
d - Accelerator Pump
90-830234R3 DECEMBER 1997
a
53430
b
53429