Cleaning And Inspection; Rewind Starter Reassembly - Mercury 75 Service Manual

Cleaning and Inspection

1. Clean components in solvent and dry with com-
pressed air.
2. Inspect rewind spring for kinks, burrs, corrosion
of breakage.
3. Inspect starter sheave, rope guide and starter
housing for nicks, grooves, cracks, wear or dis-
tortion, especially area of rope travel.
4. Inspect bushing, starter drive pawl and spring for
wear or damage.
5. Inspect starter rope for wear.
6. Replace components as necessary.

Rewind Starter Reassembly

WARNING
When reassembling rewind starter, SAFETY
GLASSES must be worn in case rewind spring
uncoils out of the housing.
1. Install spring/cover assembly into sheave.
a - Spring Assembly
90-830234R3 DECEMBER 1997
2. Install starter sheave to housing and secure in
a - Starter Sheave
b - Screw
3. Install interlock lever, cam and spring into hous-
a
a - Cam
b - Spring
c - Interlock Lever
51607
place with screw. Torque to 135 lb. in. (15.3 N·m).
ing. Position spring on cam as shown.
b
a
b
51605
a
c
51605
MANUAL STARTER - 8A-5