Honeywell VISTA-32FBPT Installation And Setup Manual page 90

D
• Daily Schedule: A partition can have a daily schedule created. This schedule is generally used to determine when the system will
Auto Arm and/or Disarm, but it can also be used for special reporting purposes.
• Default Screen: On Alpha Keypads, when the system is disarm the default message is "Disarmed . . . Ready to Arm". On some
controls, this default screen can be changed by the installer to say anything up to 32 characters.
• Direct-Downloading: (*see also download) Allows the installer to connect directly to the control panel on site via a laptop without a
phone line.
• Disarm: To turn the system OFF
• Download: To send the program data or commands in the Computer to the control panel
• Download ID Number: A user-changeable 8-digit number that is downloaded to the control panel on the initial connection, and
must match on any future connection.
• D.T.M.F.: Abbreviation for Dual Tone Multi-Frequency, or Touch Tone
• Dual Reporting: When the same report goes to two separate central station or receivers
E
• ECP: Abbreviation for Enhanced Console Protocol; This is the way that devices such as addressable keypads, wireless receiver
and relay modules "talk" to the control panel on the keypad buss.
• EOLR: Abbreviation for End of Line Resistor used on Zones
• EOLSR: Abbreviation for End of Line Supervision Relay used on 4-wire smoke detector zones.
• Earth Ground: All control panels provide an Earth Ground terminal to wire to a ground post. This ground connection can be used
to ensure protection against lightning hits and power surges; as a reference point for supervising telephone lines and zone wiring
ground fault detection
• Encryption: Encoding; Encryption is used in the Compass Downloading Software to encode account files. Also used in wireless to
prevent code stealing
• End of Line Supervision Relay: Relay used to supervise the power on 4-wire smoke detectors
• Event Log: In some controls events can be stored for later viewing; *Events; Event Log Types.
• Events: Situations that have occurred, i.e. Alarms, Troubles, Arming, Disarming, etc.
• Event Log Types: The event log stores events in many categories such as: Alarms, Checks (troubles), Bypasses, Open/Close
(Disarm/Arm) System (loss of ac, battery, etc.), and Test
• Exit Error Alarm: An alarm caused by leaving an entry/exit door open after arming.
• Expansion Module: On some controls additional modules may be used to add zones. May be a wireless, Multiplex (polling loop),
or Hardwire Zone module.
• Expansion Zones: Zones that are added to the system; May be wireless, Multiplex, or Hardwire Zones.
F
• F.M.: Factory Mutual; Agency listing for commercial fire controls nation-wide
• Factory Default: All controls come from the factory with a set of default values for each option; these defaults are the most popular
choices for each available options; Factory defaults can be loaded at anytime by hitting *97 in the panels program mode.
• Fixed Word: All Honeywell keypads use English language displays; some keypads ("alpha") are capable of fully programmable
alpha-numeric description for each zone; other keypads are non-alpha programmable but uses Fixed Glass words on the display,
such as Ready, Not ready, Armed, Disarmed, etc.
• Forced Bypass: To automatically bypass all open zones at once.
G
• Global-Arm/Disarm: In a multi-partitioned system users that have access to more than one partition may have the option to
arm/disarm all of their accessible partitions at the same time.
• Go/No Go Test: This is a patented test (for wireless systems) that gives the installer a definitive Yes or No as to the placement of
wireless transmitters.
• GoTo: In a partitioned system the GoTo command allows users, with access to more than 1 partition, to log on and control one
partition from another partition's keypad
• GUI: Graphic User Interface
90