Table of Contents
Advertisement
Replacing the high and low beam bulbs
Before replacing a burnt-out bulb, make sure that the
new one matches the voltage and wattage
specifications in paragraph "Electric System".
Always ensure that the new bulb you have installed
operates properly before refitting any parts you have
removed.
(Fig. 195) shows the locations of the parking light LED
unit (1), low beam LED unit (2) and high beam lights
(3).
To access the right or left side headlight bulbs,
remove the corresponding panel, proceeding as
follows.
Note
The figures show the replacement of the lights
on the right side of the headlight: the procedure is the
same for the left side ones.
Remove the panel cover (2).
270
3
2
1
2
3
LO
1
Fig. 195
Fig. 196
Advertisement
Table of Contents
