Danfoss ECL Comfort 210 Installation Manual page 115

Installation Guide
MENU > Alarm > Air quality
MENU > Alarm > Inlet pressure
MENU > Alarm > Outlet pressure
MENU > Alarm > Refill tank
MENU > Alarm > S7 (S8, S9, S10) pressure
Alarm high
Circuit
All
When the measured value gets higher than the set value, the alarm will
be activated.
* See Appendix "Parameter ID overview"
Value: Set the alarm value
MENU > Alarm > Air quality
MENU > Alarm > Heat recovery
MENU > Alarm > Inlet pressure
MENU > Alarm > Outlet pressure
MENU > Alarm > Refill tank
MENU > Alarm > S7 (S8, S9, S10) pressure
Alarm low
Circuit
All
When the measured value gets lower than the set value, the alarm will be
activated.
* See Appendix "Parameter ID overview"
Value: Set the alarm value
MENU > Alarm > Air quality
MENU > Alarm > Frost thermostat
MENU > Alarm > Heat recovery
MENU > Alarm > Inlet pressure
MENU > Alarm > Low pressure
MENU > Alarm > Outlet pressure
MENU > Alarm > Refill tank
MENU > Alarm > S7 (S8, S9, S10) pressure
Alarm time-out
Circuit
All
The alarm is activated when the alarm reason has been present for a longer
time (in seconds) than the set value.
* See Appendix "Parameter ID overview"
Value: Set the alarm time-out
Danfoss District Energy
ECL Comfort 210 / 310, application A266
1x614
Setting range Factory setting
*
1x615
Setting range Factory setting
*
1x617
Setting range Factory setting
*
*
*
*
VI.KT.X3.02 DEN-SMT/DK 115