Executing Ipl In Program Load Frame: Detail-1 - Fujitsu S140 User Manual

Standard processing in SVP mode
Catalog parameters
Ê Press the
The values entered are saved and thus made known to the SVP. These settings are
accessed for each IPL.

6.5.5 Executing IPL in PROGRAM LOAD FRAME: DETAIL-1

The IPL can be executed manually 1according to the setting using PROGRAM LOAD
FRAME DETAIL-1.
The following are specified in the example below:
loading VM2000


dialog startup


IPL device is specified manually by the entry of the unit address


(here: loading the VM2000 from a device with the unit address A108)
Conditions
You must be in the AUXILIARY FRAME: LOAD PRESET2 screen.
Invoking the PROGRAM LOAD FRAME: DETAIL-1 screen
Ê Press the
Enter the frame code
Ê
Or enter the
i
U41161-J-Z126-1-76
key.
P12
key to return to the MODE SELECTION FRAME.
F3
and press
LD
command in line 24 and press
FR LD
After entering or
LD
PROGRAM LOAD FRAME: DETAIL-1 or the PROGRAM LOAD FRAME:
BASIC screen is displayed, depending on the INITIAL FRAME setting in the
AUXILIARY FRAME: LOAD PRESET1 screen (see page 87).
IPL in PROGRAM LOAD FRAME: DETAIL-1
.
ENTER
in the MODE SELECTION FRAME, either the
FR LD
.
ENTER
89