Table of Contents
Advertisement
User frames and subframes
Before completing this frame check, whether the correct firmware for operating BS2000 or
VM2000 is loaded by the SVP. Information on this is provided in the DETAIL-2 STATUS.
DETAIL-2 STATUS
If the settings are not correct, press the
FRAME: DETAIL-2. After correction and pressing the
will be switched back to this frame (see page 58).
If the settings are correct, complete this frame and execute the IPL.
LOAD FUNCTION ==>
1
2
3
4
5
6
7
IPL DEVICE ==> By entering the corresponding number in this field you can specify from
1
56
In this position the current settings of the PROGRAM LOAD FRAME:
DETAIL-2 are displayed.
important display
VM MODE:
NATIVE
AVM/EX
The following function is selected after the corresponding number has
been entered:
START AUTO
START FAST
START DIAL
START
SYSTEM DUMP
LOAD CLEAR
LOAD NON CLEAR
which device group an IPL is to be executed.
PRESET GROUP
Standard processing in SVP mode
Loaded firmware
for BS2000
for VM2000
key to correct the entries in PROGRAM LOAD
P9
key the settings are stored and it
P9
executes IPL: automatic startup
executes IPL: fast startup
executes IPL: dialog startup
not used
executes SLED
clears main memory before IPL
does not clear main memory before IPL
The first device address in this column is the device
from which an IPL is to be executed. The order and
number has been specified previously in (AU5)
AUXILIARY FRAME: LOAD PRESET-1.
If IPL is terminated normally, the device address list
is transferred from the PRESET GROUP to the
CURRENT GROUP.
U41161-J-Z126-1-76
Advertisement
Table of Contents
