Table of Contents
Advertisement
Standard processing in SVP mode
Swap to PROGRAM LOAD FRAME: DETAIL-2
Ê
Press the
LOAD FUNCTION ==>
IPL DEVICE ==>
UNIT ADDRESS
PARMS =>
MT CONTROL ==>
Execute IPL
Press
Ê
The following prompt appears on the screen:
***********************************
*
* ARE YOU SURE ? (ENTER Y OR N) N *
*
***********************************
!
Ê
Press
ENTER
U41161-J-Z126-1-76
key.
P9
after you have checked all the settings.
ENTER
The IPL must not be executed during system operation!
If this instruction is not heeded, BS2000 will be terminated abruptly!
to execute the IPL, or
Y
.
IPL in PROGRAM LOAD FRAME: DETAIL-1
Enter
for a dialog start.
3
Enter
for entry of a device address.
3
Enter the device address of the load device.
In this example, the previous IPL was executed
successfully from the current device with device
address
. Thus the desired address is already
A108
in the
UNIT ADDRESS
field by the SVP. Entering a
CURRENT GROUP
field loads the operating system from
IPL DEVICE
the desired device.
Enter
in the first position of the field to load
1
VM2000.
is preset. This parameter is only important for
1
loading from tape.
*
*
to cancel the procedure. Confirm your entry with
N
field. It was also entered in the
in the
2
91
Advertisement
Table of Contents
