Safety Inspection; Disposal; Safety Symbols; Data Protection - Fronius TransTig 1750 Puls Operating Instructions Manual

Safety inspection

Disposal

Safety symbols

Data protection

18
The manufacturer recommends that a safety inspection of the device is per-
formed at least once every 12 months.
The manufacturer recommends that the power source be calibrated during the
same 12-month period.
A safety inspection should be carried out by a qualified electrician
- after any changes are made
- after any additional parts are installed, or after any conversions
- after repair, care and maintenance has been carried out
- at least every twelve months.
For safety inspections, follow the appropriate national and international stand-
ards and directives.
Further details on safety inspection and calibration can be obtained from your
service centre. They will provide you on request with any documents you may
require.
Do not dispose of this device with normal domestic waste! To comply with the
European Directive 2002/96/EC on Waste Electrical and Electronic Equip-
ment and its implementation as national law, electrical equipment that has
reached the end of its life must be collected separately and returned to an ap-
proved recycling facility. Any device that you no longer require must either be
returned to your dealer or given to one of the approved collection and recycling
facilities in your area. Ignoring this European Directive may have potentially
adverse affects on the environment and your health!
Devices with the CE marking satisfy the essential requirements of the low-volt-
age and electromagnetic compatibility directive (e.g. relevant product norms
from the EN 60 974 series).
Devices with the CSA test mark satisfy the requirements of the relevant stand-
ards in Canada and the USA.
The user is responsible for the safekeeping of any changes made to the fac-
tory settings. The manufacturer accepts no liability for any deleted personal
settings.