I
Starting current
S
I
End current
E
t
Upslope
up
t
Downslope
Down
I
Main current
1
IMPORTANT! The following points apply to the pulsed welding current:
-
The power source automatically regulates the pulsing parameters as a function of the
specified main current I
-
There is no need to set any pulsing parameters
The pulsed welding current begins:
-
After the end of the starting current phase I
-
With the upslope phase t
Depending on what tAC time has been set, the pulsed welding current may continue up to
and including the end current phase I
After the tAC time has elapsed, welding continues at a constant welding current, and any
pulsing parameters that may have been set continue to be available.
IMPORTANT! To set a specified tacking time, the tAC setup parameter can be combined
with the SPt setup parameter (spot welding time).
1
S
up
(tAC setup parameter set to "ON").
E
57