Fronius TransTig 1750 Puls Operating Instructions Manual page 32

Item
(11)
(12)
30
Designation
Welding parameters overview
The welding parameters overview contains the most important welding parame-
ters to be used when welding. The sequence of welding parameters follows a
clothesline structure. Use the left and right Parameter Selection buttons to navi-
gate within the welding parameters overview.
Welding parameters overview
The welding parameters overview contains the following welding parameters:
Starting current Is
for TIG welding
Upslope t
up
the period of time when TIG welding over which the current in increased
from the starting current I
IMPORTANT! Upslope t
modes.
Main current I
1
- for TIG welding
- for MMA welding
Reduced current I
for TIG 4-step mode and TIG special 4-step mode
Downslope t
down
the period of time when TIG welding over which the current is decreased
from the main current I
IMPORTANT! The downslope t
step modes.
Final current I
E
for TIG welding
Electrode diameter
used in TIG welding to enter the diameter of the tungsten electrode
Adjusting dial
for altering welding parameters. If the indicator on the adjusting dial lights up, then
the selected welding parameter can be altered.
to the specified main current I
S
is saved separately for 2-step and 4-step
up
(welding current)
2
to the end current I
1
is saved separately for 2-step and 4-
down
1
E