Tig Welding; Safety; Welding Parameters - Fronius TransTig 1750 Puls Operating Instructions Manual

TIG welding

Safety

Welding parame-
ters
Unit
Setting range
Factory settings
Unit
Setting range
Factory settings
IMPORTANT! The upslope t
Unit
Setting range
Factory settings
IMPORTANT! On welding torches with the Up/Down function, the entire setting range
can be selected while the device is idling. During welding, the main current can be cor-
rected in steps of +/-20 A.
Unit
Setting range
Factory settings
Unit
Setting range
Factory settings
IMPORTANT! The downslope t
50
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described until you have thoroughly read and
understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the safe-
ty rules
WARNING! An electric shock can be fatal. If the power source is connected to the
mains electricity supply during installation, there is a high risk of very serious in-
jury and damage. Before carrying out any work on the device make sure that:
- the power source mains switch is in the "O" position
- the power source is unplugged from the mains
Starting current I
S
%
0 - 200 % of main current I
50
Upslope t
up
s
0.01 - 9.9
0.5
up
Main current I
1
A
2 - 170
2
Reduced current I (4-step mode)
2
% (of main current I
0 - 100
50
Downslope t
down
s
0.01 - 9.9
1.0
1
is saved separately for 2-step and 4-step modes.
)
1
is saved separately for 2-step and 4-step modes.
down