Setting Lan Parameters - JDS Uniphase HST-3000 User Manual

– PPP parameters (see
page
– LAN parameters (see
page
– WAN parameters (see
page
To synchronize with the modem at the other end, you only
need to set the general modem parameters. To use IP ping or
the web browser, you must set the other parameters as well.
Setting LAN The following procedure describes how to set the LAN param-
parameters eters.
To set the LAN parameters
1 Press the LAN soft key.
The LAN Settings menu appears.
2 Select NAT (network address translation), and then
enable or disable as appropriate.
Use this when the customer CPE modem/router assigns
private IP addresses.
3 Select Server IP, and then enter the tester's LAN server
IP address.
4 Select Netmask, and then enter the LAN net mask
address.
HST-3000 G.SHDSL Testing User's Guide
20)
35)
15)
Chapter 2 G.SHDSL Testing
Testing in G.SHDSL through mode
"Setting PPP parameters" on
"Setting LAN parameters" on
"Setting WAN parameters" on
35