Throughput Testing; Atm Bert Testing - JDS Uniphase HST-3000 User Manual

Chapter 2 G.SHDSL Testing
Testing in G.SHDSL STU-R TE mode
Throughput
testing
ATM BERT
testing
32
4 Press the 4 key, and then press the 1 key.
The IP results window appears.
5 Press the Actions soft key.
6 Select either Log-Off or IP-Release.
The Data LED goes dark.
The Log-Off and IP-Release options are only available
when you are viewing the IP results window.
The IP address is now available for use in other applications.
Using the FTP/HTTP throughput feature, you can perform a
file transfer to test the throughput of the circuit.
To test throughput
1 Specify the FTP/HTTP settings (see
parameters" on page
2 Navigate to the FTP/HTTP results screen.
3 Press the Actions soft key.
4 Select FTP/HTTP and then Enter Address.
5 Enter the address using the keypad, including the prefix
(ftp: or http: or, if applicable, https:) and the filename.
For example, ftp://10.0.0.1/name
6 Press OK to begin the file transfer.
The results appear on the screen.
See "FTP/HTTP results" on page 59
interpreting the results.
The HST-3000 allows testing of the ATM layer using a bit error
rate test (BERT). The following procedure describes how to
perform an ATM BERT.
HST-3000 G.SHDSL Testing User's Guide
"Setting FTP/HTTP
26).
for information on