Setting Wan Parameters - JDS Uniphase HST-3000 User Manual

10 If you selected IPoE, IPoA, PPPoA, PPPoE, MVC Video,
NOTE:
If the rate entered is not attainable, the HST will round
down to the next attainable rate.
11 If you selected IPoE, IPoA, PPPoA, or PPPoE Data
NOTE:
Depending on previous settings, you may have to navigate
to item 10 on the menu, and then press the down arrow to
find this selection.
12 If you selected ATM Loopback Data Mode, select Loop-
The data parameters are set.
Setting WAN The following procedure describes how to set the wide area
parameters network (WAN) parameters. The WAN interface is the DSL
connection to tip and ring.
The WAN Settings menu appears if you are using IPoE or
Multi VLAN data mode. For Multi VLAN data mode, you may
have more than one WAN screen (for example, WAN2,
WAN3).
HST-3000 G.SHDSL Testing User's Guide
or Bridged Ethernet Data Mode, select TX ATM PCR and
enter the transmit peak cell rate.
– Unlimited transmits the maximum cell rate allowed on
the circuit.
– User Specified allows you to enter a value from 2 to
50000 cells per second.
Mode, select Encapsulation, and then specify the appro-
priate setting.
back Mode and specify whether to loop ALL cells or only
TTC cells.
Chapter 2 G.SHDSL Testing
Testing in G.SHDSL STU-R TE mode
15