Setting Trace Route Parameters - JDS Uniphase HST-3000 User Manual

Setting trace route
parameters
To send this message...
Element LpBk (Terminate)
Status Request
Full Status Request
This is the message transmitted when the "Send EOC
message" menu item is selected. Change this only if
another specific message is needed.
4 If you selected one of the Element LpBk messages,
specify the Element Number to which the message will be
sent.
5 Optional. Select Req Remote Stats to request statistics
from the far end.
This setting is only available in STU-R mode.
The EOC parameters are set.
The following procedure describes how to set the trace route
parameters.
To set the trace route parameters
1 Press the Trace Route soft key. You may need to use the
left or right arrow key to find the TRACERT soft key.
The Trace Route Settings menu appears.
HST-3000 G.SHDSL Testing User's Guide
Chapter 2 G.SHDSL Testing
Testing in G.SHDSL STU-R TE mode
Press...
the 6 key
the 7 key
the 8 key
25