Setting Ftp/Http Parameters - JDS Uniphase HST-3000 User Manual

Chapter 2 G.SHDSL Testing
Testing in G.SHDSL STU-R TE mode
Setting FTP/HTTP
parameters
26
2 Select Address Type, and then select either IP address
or DNS Name (domain name server name).
3 Select IP Address, and then enter the IP address.
4 Select DNS Name, and then enter the DNS name.
5 Select Packet Type, and then set the packet type to one
of the following:
– ICMP (Internet Control Message Protocol)
– UDP (User Datagram Packet).
6 Select DNS Lookup, and then indicate whether you want
to lookup names for hops.
The trace route parameters are set.
The following procedure describes how to configure FTP/
HTTP (throughput) parameters.
To set FTP/HTTP parameters
1 Press the FTP/HTTP soft key. You may need to use the
left or right arrow key to find the FTP/HTTP soft key.
The FTP/HTTP Settings menu appears.
2 Press the 1 key, and then enter a user name. Use the up
and down arrows to indicate a letter or number, or use the
keyboard keys.
3 Press the OK key to accept the changes.
HST-3000 G.SHDSL Testing User's Guide