Setting Atm Bert Parameters - JDS Uniphase HST-3000 User Manual

Chapter 2 G.SHDSL Testing
Testing in G.SHDSL STU-R TE mode
Setting ATM BERT
parameters
22
IP Address uses the numeric address, DNS Name uses
the domain name, such as www.jdsu.com
3 Select IP Address, and then enter the IP address.
We recommend you use the IP address or Domain Name
Services (DNS) name of the ISP gateway of the
customer's service provider. It is also possible to ping any
internet address or the network Broadband Remote
Access Server (BRAS).
4 Select DNS Name, and then enter the DNS name.
5 Select Number Pings, and then set the number of pings
to send before stopping.
6 Select Pings/second, and then set the number of pings
per second.
7 Select Packet size, and then set the packet size.
The default is 16. Change this only if needed.
The ping parameters are set.
If you selected ATM BERT as the data mode on the Data
settings menu, the ATM BERT parameters must be set. The
ATM BERT data mode is only available in modem emulate
mode.
To set the ATM BERT parameters
1 Press the ATM BERT soft key.
HST-3000 G.SHDSL Testing User's Guide